Foxconn N15235 Motherboard Front Panel Connectors Link

If you want, I can:

Given the above pinout, here is how to connect each component:

Q1: Where can I buy a replacement front panel connector block for the Foxconn N15235?
A: You cannot buy a new one easily, but you can use dupont jumper wires (female to female) to connect your case’s individual leads. Search for “2.54mm pitch jumper wires” on Amazon or eBay. foxconn n15235 motherboard front panel connectors

Q2: I lost the original case. Can I use this motherboard in a new case?
A: Absolutely. The N15235 uses standard ATX front panel pin spacing (2.54mm). Any modern case’s front panel cables will fit. Just follow the pinout in Section 3.

Q3: My case has a single 8-pin block connector. Will it work?
A: Possibly, but check the pinout. Many OEM cases (Acer, Dell) use proprietary block connectors that are not compatible. You may need to cut the block and separate the wires. If you want, I can:

Q4: Is there a BIOS setting to change front panel behavior?
A: No. The front panel is purely hardware-controlled. Check BIOS only for “Power On By Keyboard/Mouse” – unrelated to physical buttons.

Q5: What is the missing pin for?
A: It is a physical key to prevent you from plugging the connector in upside down. Always align your connector so that the blocked hole goes over the missing pin. Given the above pinout, here is how to

First, power down your system and unplug the PSU. Open the case and locate the motherboard. The front panel header is almost always situated in the bottom-right corner of the board, near the SATA ports and the front-panel audio connector.