pidstat -d 1
The error: You terminate the end of the cable, but the service loop is on the source side, not the destination side. The consequence: When a connector fails, you have to cut the loop off the source (which is usually in a hard-to-reach ceiling), leaving you with a cable that is now too short. The fix: The "run top" goes at the head end (rack, closet, TV location). The far end (camera, wall jack) usually does not need a loop. hdking run top
Before we dive into the technique, let's deconstruct the keyword. In cabling slang: pidstat -d 1 The error: You terminate the
Thus, an HDKing run top is a professionally executed, high-density service loop located at the termination point (rack, patch panel, or wall plate). It is a coil of slack cable, neatly dressed and secured, that sits just behind or above your termination panel. Thus, an HDKing run top is a professionally
In layman’s terms: It is the extra "give" you leave in the wire so you don’t have to repull the entire length if a connector breaks or equipment moves.