Landxcape Firmware Update

Even with careful planning, updates can fail. Here is the troubleshooting hierarchy:

| Symptom | Likely Cause | Solution | | :--- | :--- | :--- | | App says "Timeout" | Weak Wi-Fi signal to the base station | Move the charging base closer to the router or install a Wi-Fi extender. | | Mower beeps endlessly | Corrupt firmware download | Force stop the app. Remove the safety key from the mower for 10 seconds. Reinsert and restart the process. | | LED stays solid red | Bootloader crash | This is rare. You must perform a manual USB recovery (see below). | | Mower cuts grass poorly after update | Settings were reset to default | The update often wipes custom schedules. Re-enter your cutting height, schedule, and zone settings. | landxcape firmware update

Tap the gear icon (Settings) in the top right corner of the home screen. Scroll down to the "Device Information" or "Maintenance" section. This is where the firmware version is displayed (e.g., v2.1.34). Even with careful planning, updates can fail

There are two methods to update your Landxcape. Method A (Automatic) is the standard. Method B (USB/SD Card) is for models without Wi-Fi modules. Remove the safety key from the mower for 10 seconds

Older firmware would shut down the mower if the blade disc sensor detected moisture, thinking it was a collision. New firmware adjusts the sensitivity threshold, allowing the mower to run at 6 AM even with heavy morning dew.

The mower will beep twice and restart. This takes 60–90 seconds. Do not touch the mower or the STOP button during this phase.

Landxcape updates are rarely pushed "over-the-air" (OTA) via Wi-Fi like a smartphone. Instead, they are usually distributed via:

Even with careful planning, updates can fail. Here is the troubleshooting hierarchy:

| Symptom | Likely Cause | Solution | | :--- | :--- | :--- | | App says "Timeout" | Weak Wi-Fi signal to the base station | Move the charging base closer to the router or install a Wi-Fi extender. | | Mower beeps endlessly | Corrupt firmware download | Force stop the app. Remove the safety key from the mower for 10 seconds. Reinsert and restart the process. | | LED stays solid red | Bootloader crash | This is rare. You must perform a manual USB recovery (see below). | | Mower cuts grass poorly after update | Settings were reset to default | The update often wipes custom schedules. Re-enter your cutting height, schedule, and zone settings. |

Tap the gear icon (Settings) in the top right corner of the home screen. Scroll down to the "Device Information" or "Maintenance" section. This is where the firmware version is displayed (e.g., v2.1.34).

There are two methods to update your Landxcape. Method A (Automatic) is the standard. Method B (USB/SD Card) is for models without Wi-Fi modules.

Older firmware would shut down the mower if the blade disc sensor detected moisture, thinking it was a collision. New firmware adjusts the sensitivity threshold, allowing the mower to run at 6 AM even with heavy morning dew.

The mower will beep twice and restart. This takes 60–90 seconds. Do not touch the mower or the STOP button during this phase.

Landxcape updates are rarely pushed "over-the-air" (OTA) via Wi-Fi like a smartphone. Instead, they are usually distributed via: