Mptool - Ys9082hp

If you are looking into this because of cybersecurity, there is a concept known as "BadUSB" or "USB Multiplexers."

Researchers often use MPTools to reprogram USB controllers for security research. For example:

This scans for USB VID/PID pairs. Crucial Note: Out of the box, a blank YS9082HP may not enumerate properly. It often defaults to a "BootROM" mode with a generic VID (e.g., 1AAA or 145F). The MPTool must recognize this BootROM state to begin flashing.

Open your SSD physically (warranty void). Look at the NAND chip(s) – they have markings like NW817 (Micron), TT18G23A1 (YMTC), H25QFT8B1 (SK Hynix). Write down the Flash ID if possible (some MP tools have a "Check Flash ID" button).

Note: replace placeholders (DEVICE, IMAGE, PARTITION) with actual names/paths from your setup. ys9082hp mptool

  • Flash a firmware image (single partition)

    mptool --flash --partition rootfs --file ./images/rootfs.img DEVICE
    
  • Backup partitions

    mptool --backup --partition bootloader --out ./backups/bootloader.bin DEVICE
    mptool --backup-all --out ./backups/ys9082hp-$(date +%F).img DEVICE
    
  • Restore partition or full image

    mptool --restore --partition kernel --file ./backups/kernel.bin DEVICE
    mptool --restore-all --file ./backups/ys9082hp-2026-03-22.img DEVICE
    
  • Read/write EEPROM/config

    mptool --eeprom-read --out eeprom.bin DEVICE
    mptool --eeprom-write --in new-eeprom.bin DEVICE
    mptool --set-param mac 00:11:22:33:44:55 DEVICE
    
  • Serial console bridge

    mptool --serial --baud 115200 DEVICE
    
  • Diagnostic tests

    mptool --diag --memtest DEVICE
    mptool --diag --network DEVICE
    mptool --log --follow DEVICE
    
  • Scripting for batch flashing

  • Do not download the first version you see. YS9082HP tools are highly version-specific. If you are looking into this because of

    Useful sources: USBDev.ru, Reddit SSD communities, or ChinaFlashMarket.

    Before flashing, try this: Put the SSD in an external enclosure, run HDD Low Level Format Tool for 10 seconds, stop it, and plug it back into SATA. Some users report the YS9082HP resets itself without needing the MPtool.


    Meaning: The firmware in the tool does not match the NAND type. Fix: Find a different MPtool version. Look for one specifically compiled for your NAND brand (e.g., "YS9082HP_Toshiba_64L").

    Комментарии 6

    1. Rifovich
      опубликовано: 24 августа 2020 03:17
    2. MrKrabs
      опубликовано: 16 сентября 2020 10:45
    3. kulibin75
      опубликовано: 10 марта 2023 11:30
    4. Abzal1980
      опубликовано: 25 марта 2023 08:00
    5. rurikovich опубликовано: 6 октября 2024 07:00
    6. georgalania опубликовано: 21 января 2025 22:30
    Информация
    Посетители, находящиеся в группе Гости, не могут оставлять комментарии к данной публикации.